Original Equipment wiper blade refills.

11.00 plus shipping.

New lock for your ignition switch. Comes with 2 keys.

15.00

New reproductions, Cadillac glove box script. Comes with 2 push nuts

50.00 plus shipping.

1964 Cadillac Comfort Control Troubleshooting book.

This is a must have to figure out why your heat of AC is not working correctly.

45.00 plus shipping.

Gaskets to install a new water pump.

Price is 15.00

Includes the oil filter housing and mount bracket gaskets, water pump to heads gaskets, and an O ring.

Since new water pumps come with a new O ring and water pump gasket, those are not included. If you want those 2 seals, they are an additional 3.00

Front Brake hose, fits all models.

20.00 plus shipping.

A new reproduction of the original battery cable clip. This comes with the lock pin, just like the original piece. 20.00

New design T shirts are 18.50 Gray only. L ,XL, XXL
Back is printed like the original design.

This new wire harness plugs directly into your existing headlight wire harness. It uses 2 relays to directly connect the headlights to the battery. The headlights are brighter, and the dash lights are brighter.

This is because the stock factory wire harness draws power from the battery, to the fuse box, up to the headlight switch, out to the headlights. That's a lot of old connections and wires. You do not need to cut any wires.

Price is 70.00, and the wrap may be yellow or black.

Refurbished clocks by The Clock Works. I have refurbished clocks from 80.00 to 150.00 It all depends on the condition of the chrome bezel and lens.

I have clocks with new chrome bezels and new lens's for 175.00
email me to see what I have in stock.

In XL and XXL only The back of the T shirt has the shop name and web address.

99.00% cotton, pre-shrunk.

Shirts are 12.00

Back of the T shirts

Reproduction for the 64 windshield washer reservoir.

10.00 each

New tilt steering column horn contact plunger.

25.00 plus shipping.

new seal for the round screw on caps for the master cylinder. 3.00 each

This is the rubber button for the trip odometer.

8.00 plus shipping.

These carrier bearings were revulcanized from Steele Rubber. Original cores were used, and a new carrier bearing was pressed into place. Ready to go into your classic car, avoid the wait time of 3 weeks to get one revulcanized.

Price 195.00 plus a 50.00 core charge.

Adaptor for the stock air cleaner. get your stock air cleaner to fit onto the Edelbrock carb you just put on. Made of high temp resistant tough plastic, it wont break.

50.00 plus 6.00 in priority USA shipping.

Simplify the LED tail light assembly installation with this plug.
The reason I do not include this already installed is that due to the low voltage resistance, deposits form on the contacts, and the contacts need to be cleaned every year, to avoid problems.

You get 2 adaptor plugs for 5.00

New LED lights for the tail lights. Brake turn signal and running lights only.
Easy to install, with 2 methods of installation.

Method #1; Cut the stock wires right at the back of the light housing and route the new wires through the original wire holes. Connect the 2 light wires together, and connect the ground wire to a good ground.
Method #2; Purchase the bulb adapter connector. Connect the 3 wires and plug in.
250.00 or 255.00 with adapter, see adapter for details.

Get a fuse block repair kit to put new clips in place of the rusted clips you have. Comes with the correct number of clips and solid rivets to install new clips.
1963 fuse block is 65.00 and the 1964 fuse block is 70.00

Or send me yours to refurbish for (63) 120.00 (64) 125.00

New reproduction part. Fits the 63/64 tilt steering column. This goes to the bowdens cable for the turn signal mechanism. Part is 30.00

The 4 rivets marked in white are what usually wear. The 2 smaller rivets always wear, causing the hood to lift. You need to drill out the 2 larger rivets marked in white, to replace the smaller rivets.

There are 2 sizes of rivets on the hood hinge. 4 smaller, and 3 larger. A machine shop will need to machine a shoulder into the rivet.
Rivets are 1.50 each, and there are 7 rivets per hinge.